Canon FINISHER-C1 Service Manual page 165

7. Removing the Positioning Plate
Unit
1) Remove the PCB cover.
2) Remove the saddle stitcher controller (4
screws [1], 13 connectors [2])
3) Disconnect the two connectors [3] (motor,
paper sensors) and two screws [4].
4) Slide the unit [5] right and left to remove it.
COPYRIGHT © 1998 CANON INC. FINISHER-C1/SADDLE FINISHER-C2 REV. 0 DEC. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 4 MECHANICAL CONSTRUCTION
[ 1 ] [ 2 ]
[ 1 ]
Figure 4-140B
Figure 4-141B
[ 2 ] [ 2 ] [ 1 ]
[ 2 ] [ 1 ]
[ 5 ]
[ 3 ]
[ 4 ]
4-35