Canon FINISHER-C1 Service Manual page 111

4) When the following stack arrives, the foregoing steps 1 through 3 are repeated.
5) The alignment plates butt against the stack once again, during which stitching takes place.
6) The alignment plates escape to points 10 mm from the edges of the stack, after which folding
and delivery take place.
7) When the first sheet of the following stack reaches the No. 1 paper sensor, the guide moves to
a point 10 mm from the edge of the stack to be ready for the next alignment operation.
In case of 2 sheets :
Alignment plate home
position sensor (PI5)
Alignment motor (M5S)
1: Stapling period
2: Paper folding/delivery period
*Direction depends on the size of paper.
COPYRIGHT © 1998 CANON INC.
CHAPTER 3 SADDLE STITCHER UNIT BASIC OPERATION
Figure 3-312
      
 
Figure 3-313
Figure 3-314
1st sheet
deposit
[1]
A lignment
Figure 3-315
FINISHER-C1/SADDLE FINISHER-C2 REV. 0 DEC. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)
2nd sheet 1st sheet of following
deposit stack deposit
[2] [3]
Escape
3-23