Electrical Installation - Parker 590+ DRV Product Manual

Electrical Installation

IMPORTANT
Please read the Safety Information on page Cont. 3 & 4 before proceeding.
This Chapter deals only with a "general purpose" operation as a basic speed controller, because of the complexity of showing all possible
configurations.
Special wiring instructions usually form part of a customer-specific system and connection details will be provided separately.
Power terminals carry electrical voltage, which can be lethal. Never work on any control equipment or motors
To avoid damaging the drive NEVER carry out high voltage resistance or dielectric strength tests without first completely disconnecting the drive from
Incorrect wiring is a common cause of start up problems. If you have questions about wiring procedures, contact Parker SSD Drives Product Support.
DC590+ DRV Series DC Digital Drive
without first removing all power supplies from the equipment.
Make sure all wiring connections meet or exceed applicable local and National Electrical Codes.
Be sure to fit branch circuit and motor overload protection.
WARNING
Caution
the circuit being tested.
Caution
3-5
Installing the Drive