Serial Links - Parker 590+ DRV Product Manual

6-18
The Keypad

SERIAL LINKS

This menu contains 3 function blocks. These can be found in the SETUP PARAMETERS menu - refer to Appendix D: "Programming".
SERIAL LINKS
•_ TEC OPTION
•_ SYSTEM PORT (P3)
•_ PNO CONFIG
SYSTEM
This menu contains 2 parameters and 3 function blocks. The function blocks can be found in the SETUP PARAMETERS menu - refer to Appendix D:
"Programming".
SYSTEM
•_ SOFTWARE
•_ CONFIGURE I/O
•_ miniLINK
•_ SAVE TO OP
•_ LOAD FROM OP
SOFTWARE Parameter
This parameter displays the software release of the firmware in the drive.
CONFIGURE I/O Parameter
This parameter is repeated in several menus. It is used whenever you want to save any changes that are made to a parameter.
Refer to Appendix D: "Programming" - Modifying a Block Diagram.
PARAMETER SAVE
Refer to "Saving Your Application", page 6-23.
refer to Appendix D:"Programming"
refer to Appendix D:"Programming"
refer to Appendix D:"Programming"
see below
see below
refer to Appendix D:"Programming" - miniLINK
refer to Appendix D:"Programming" - CONFIGURE DRIVE
refer to Appendix D:"Programming" - CONFIGURE DRIVE
DC590+ DRV Series DC Digital Drive