Parameter Tables - Parker 590+ DRV Product Manual

Parameter Tables

The headings for the Tag No. table are described below.
Tag
Mn
MMI Block Name
MMI Parameter Name
Minimum/Maximum/
Default/Units/Range
Notes
Parameter Types:
Parameters that look like 0x0000 are WORDS
Parameters that have text are BOOLs if they have a range of 0,1
Parameters that have text are WORDS if their range is 0 to greater than 1
All other parameters are INT (integers)
If a parameter can only be written to in Config mode, this implies that the drive is stopped.
DC590+ DRV Series DC Digital Drive
A numeric identification of the parameter. It is used to identify the source and destinations of internal links.
Serial Communications Mnemonic:
Refer to Appendix A: "Serial Communications"
The menu page under which the parameter is stored on the MMI.
The parameter name as it appears on the MMI.
The Range varies with parameter type:
INT The upper and lower limits of the parameter, indicating the parameter's true, internally-held, number of
decimal.
Note:
Decimal Places - some internally held parameters with two decimal places are only displayed
with one decimal place. These parameters are indicated in the Parameter Description tables. The
Range parameter highlights these with "(h)".
BOOL 0 = FALSE, 1 = TRUE
WORD 0x0000 to 0xFFFF (hexadecimal)
Output parameters are not saved in non-vol memory unless noted otherwise.
Input parameters are saved in non-vol memory unless noted otherwise.
View levels: Write qualifiers:
V0 Normal W0
V1 Advanced W1
W2
W3
W4
Parameter Specification Tables
Always
Only when stopped
Only when in configuration mode
Only in thee-button reset mode
Read only, (output parameters)
C-1