Mounting Instructions - Parker 590+ DRV Product Manual

3-2
Installing the Drive

Mounting Instructions

The DC590+ DRV Digital drive is designed to mount directly onto a vertical, flat surface. All models are designed with the incoming three-phase
supply connections the motor connections at the bottom. Units rated 125 through 500 HP have terminals for the motor field connections and optional
motor blower connections mounted on the left. Keep the terminal locations in mind when mounting the drive to accommodate proper wire routing.
Recommended Tools
Installing a DC590+DRV DC Digital Drive requires a few standard hand tools. A socket wrench to fit either ¼-20 or M6 (as applicable) bolts and nuts
is needed to mount the drive to the panel. Screwdrivers and a wire-crimping tool are needed to make various electrical connections. For installing
DRVs larger than 165A, wrenches are needed to make some of the electrical connections.
Below is a list of some of the required tools.
Socket wrench with a 6 inch extension
Deep sockets: M10, M13, M17, 7/16", 1/2"
Screwdrivers: Phillips #2, flat blade - 0.5 x 3.0mm, 0.6 x 3.5mm, 0.8 x 4.0mm
Small wire cutters
NOTE
Holes for the mounting bolts or screws must be placed accurately.
IMPORTANT
When drilling mounting holes, cover any components already mounted to the panel to protect them from stray metal
filings.
Mounting the Units
Insert the mounting studs from the back side of the panel. Attach lock washers and nuts part way onto the lower mounting studs. They will help keep
the drive in place when mounting.
Lower the bottom slots of the DC590+ DRV Digital drive onto the studs, making sure the slots are between the washers and the panel. Once the drive
is resting on the bottom studs, lean it back onto the top two studs. Attach lock washers and nuts on the top studs and finger tighten. Finger tighten the
lower studs as well to hold the drive in place. Finally, use the socket wrench to tighten all four nuts securely.
Visually check the drive and its housing for packing material, mounting debris, or any other material that could damage and/or restrict the operation of
the equipment.
WARNING
The DC590+ DRV units are heavy. Use proper lifting techniques when moving.
DC590+ DRV Series DC Digital Drive