AudioCodes Mediant 1000B User Manual page 325

User's Manual
2. Click New; the following dialog box appears:
Figure 16-7: Quality of Service Rules Table - Dialog Box
3. Configure a rule according to the parameters described in the table below.
4. Click Apply, and then reset the device with a save-to-flash for your settings to take
effect.
Table 16-6: Quality of Service Rules Table Parameter Descriptions
Parameter
Match
Index
[QualityOfServiceRules_Index]
IP Group
ip-group-name
[QualityOfServiceRules_IPGroup
Name]
Rule Metric
rule-metric
[QualityOfServiceRules_RuleMetr
ic]
Severity
severity
[QualityOfServiceRules_Severity]
Version 7.2
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
Assigns an IP Group. The rule applies to all calls belonging to the
IP Group.
Defines the performance monitoring call metric to which the rule
applies if the metric's threshold is crossed.

[0] Voice Quality = (Default) The device calculates MOS of
calls and if the threshold is crossed (i.e., poor quality), the
configured action (see 'Rule Action' parameter below) is done
for all new calls and for the entire IP Group.

[1] Bandwidth

[2] ACD

[3] ASR

[4] NER

[5] Poor InVoice Quality = The device calculates MOS (and
TMMBR) of the call and if the threshold is crossed (i.e., poor
quality), the device uses a different IP Profile (see 'Rule
Action' parameter below) for the current call only (not the
entire IP Group).
Defines the alarm severity level. When the configured severity
occurs, the device performs the action of the rule.

[0] Major (Default)

[1] Minor
Note: If you configure the 'Rule Metric' parameter to ACD, ASR
or NER, you must configure the parameter to Major. For all other
'Rule Metric' parameter values, you can configure the parameter
325
16. Quality of Experience
Description
Mediant 1000B Gateway & E-SBC