AudioCodes Mediant 500L User Manual page 1130

Parameter
display-info
[CallerDisplayInfo]
Enable Caller ID
configure voip > gateway dtmf-supp-
service supp-service-settings > enable-
caller-id
[EnableCallerID]
Caller ID Type
configure voip > gateway dtmf-supp-
service supp-service-settings > ccaller-
ID-type
[CallerIDType]
User's Manual
party can use this information for caller identification. The
information configured in this table is sent in the SIP INVITE
message's From header.
The format of the ini file table parameter is as follows:
[CallerDisplayInfo]
FORMAT CallerDisplayInfo_Index =
CallerDisplayInfo_DisplayString,
CallerDisplayInfo_IsCidRestricted,
CallerDisplayInfo_Module, CallerDisplayInfo_Port;
[\CallerDisplayInfo]
Where,


Module = Module number, where 1 denotes the module
in Slot 1.

Port = Port number, where 1 denotes Port 1 of a module.
For example:
CallerDisplayInfo 0 = Susan C.,0,1,1;
as the Caller ID for Port 1 of Module 1)
CallerDisplayInfo 1 = Mark M.,0,1,2;
as Caller ID for Port 2 of Module 1)
For more information, see Configuring Caller Display
Information on page 616.
Note:

The indexing of this table ini file parameter starts at 0.

The parameter is applicable only to analog interfaces.
Global parameter that enables Caller ID.

[0] Disable (default)

[1] Enable =

FXS: The calling number and display text (from IP)
are sent to the device's port.

FXO: The device detects the Caller ID signal
received from the Tel and sends it to the IP in the
SIP INVITE message (as the 'Display' element).
To configure the Caller ID string per port, see Configuring
Caller Display Information on page 616. To enable or
disable caller ID generation / detection per port, see
Configuring Caller ID Permissions on page 620
Determines the standard used for detection (FXO) and
generation (FXS) of Caller ID, and detection (FXO) /
generation (FXS) of MWI (when specified) signals:

[0] Standard Bellcore = (Default) Caller ID and MWI

[1] Standard ETSI = Caller ID and MWI

[2] Standard NTT

[4] Standard BT = Britain

[16] Standard DTMF Based ETSI

[17] Standard Denmark = Caller ID and MWI

[18] Standard India

[19] Standard Brazil
Note:

The parameter is applicable only to analog interfaces.
1130
Mediant 500L Gateway & E-SBC
Description
("Susan C." is sent
("Mark M." is sent
Document #: LTRT-10532