AudioCodes Mediant 500L User Manual page 1184

Parameter
Dial Tone Duration
configure voip > gateway dtmf-
supp-service dtmf-and-dialing > dt-
duration
[TimeForDialTone]
Stutter Tone Duration
configure voip > gateway dtmf-
supp-service supp-service-settings
> sttr-tone-duration
[StutterToneDuration]
FXO AutoDial Play BusyTone
configure voip > gateway analog
fxo-setting > fxo-autodial-play-
bsytn
[FXOAutoDialPlayBusyTone]
Hotline Dial Tone Duration
configure voip > gateway dtmf-
supp-service dtmf-and-dialing >
hotline-dt-dur
[HotLineToneDuration]
User's Manual

[0] Disable (default)

[1] Enable
Note: The parameter is applicable only to analog interfaces.
Defines the duration (in seconds) that the dial tone is played to
an ISDN terminal.
The parameter is applicable for overlap dialing when
ISDNInCallsBehavior is set to 65536. The dial tone is played if
the ISDN Setup message doesn't include the called number.
The valid range is 0 to 60. The default is 5.
For analog interfaces: FXS interfaces play the dial tone after
the phone is picked up (off-hook). FXO interfaces play the dial
tone after the port is seized in response to ringing (from
PBX/PSTN). The valid range is 0 to 60. The default time is 16.
Note for analog interfaces:

During play of dial tone, the device waits for DTMF digits.

The parameter is not applicable when Automatic Dialing is
enabled.
Defines the duration (in msec) of the confirmation tone. A
stutter tone is played (instead of a regular dial tone) when a
Message Waiting Indication (MWI) is received. The stutter tone
is composed of a confirmation tone (Tone Type #8), which is
played for the defined duration (StutterToneDuration) followed
by a stutter dial tone (Tone Type #15). Both these tones are
defined in the CPT file.
The range is 1,000 to 60,000. The default is 2,000 (i.e., 2
seconds).
Note:

The parameter is applicable only to FXS interfaces.

If you want to configure the duration of the confirmation tone
to longer than 16 seconds, you must increase the value of
the parameter TimeForDialTone accordingly.

The MWI tone overrides the call forwarding reminder tone.
For more information on MWI, see Message Waiting
Indication on page 579.
Determines whether the device plays a busy / reorder tone to
the PSTN side if a Tel-to-IP call is rejected by a SIP error
response (4xx, 5xx or 6xx). If a SIP error response is received,
the device seizes the line (off-hook), and then plays a busy /
reorder tone to the PSTN side (for the duration defined by the
parameter TimeForReorderTone). After playing the tone, the
line is released (on-hook).

[0] = Disable (default)

[1] = Enable
Note: The parameter is applicable only to FXO interfaces.
Defines the duration (in seconds) of the hotline dial tone. If no
digits are received during this duration, the device initiates a
call to a user-defined number (configured in the Automatic
Dialing table - TargetOfChannel - see Configuring Automatic
Dialing on page 615).
The valid range is 0 to 60. The default is 16.
1184
Mediant 500L Gateway & E-SBC
Description
Document #: LTRT-10532