Reference Manual
00809-0100-4570, Rev DA
9.7.2
Selecting properties to be displayed
The alerts indicated per vessel can be selected. To select alerts for a vessel, right-click a vessel
rectangular box (when a site is selected) and select Properties. The Parameters Definition window for
the specific vessel opens
In the Data Selection tab choose the parameters to appear in the vessel box under the site selection. By
default, the following parameters are selected and shown:
Distance/Level (the distance or level parameter is shown as configured)
Maximum and Minimum Distance/Level
Volume (%)
Figure 9-3. Parameter Definition - Data Selection
Parameters can be removed and added, and the order they appear inside the vessel box can be changed.
To remove a selected parameter, select the parameter for removal and select
To remove all selected parameters, select
To add a parameter, select the parameter from the Available pane and select
To add all available parameters, select
To move a selected parameter up, select the parameter from the Selected pane and select
To move a selected parameter down, select the parameter from the Selected pane and select
9.7.3
Setting alert threshold
The alert threshold is specified in the Alerts tab of the Parameters Definition window
triggers an alert when the material volume is above or below these values.
Service and Troubleshooting
(Figure
9-3).
.
.
Service and Troubleshooting
November 2017
.
.
(Figure
.
.
9-4). This
153