Emerson Rosemount 5708 Reference Manual page 135

Reference Manual
00809-0100-4570, Rev DA
Hardware inventory table
The hardware inventory table lists the following:
All sites included in the project with their names, descriptions, and server names.

For each site, the included vessels are listed with their names.

For each vessel, the devices related to that vessel are listed below it.

The table contains the following properties per the included items: Vessel, Serial Number, Hardware and
Firmware versions of the devices, Polling Address, model, and Connection type, Communication Port,
Chain ID and SCADA ID.
Note
SCADA ID - Each vessel gets its own SCADA ID, and each scanner has a separate SCADA ID. This allows
separating measurements of scanners from the vessel in multi-scanner system.
Chain ID is used in cases where the Rosemount 3DMultiVision is connected to multiple devices over
multiple chains and the user wants to connect to a specific device from the Rosemount 3DVision.
SCADA ID is assigned per vessel and used when connecting a SCADA system to retrieve the registers of
the vessel.
To create a hardware inventory table:
Select Tools > Reports > Hardware Inventory Table. The table opens in a separate window

7-94).
The data displayed is updated when the Refresh button is selected.
Figure 7-94. Hardware Inventory Table
Measurement summary table
The measurement summary table lists the Volume (absolute), Volume %, Mass, and Alerts for all vessels
on all sites, grouped by site.
The table lists the measurement units reported by the devices.
To activate the measurement summary table:
Select Tools > Reports > Measurement Summary Table. The table opens in a separate window

(Figure
Select the Refresh to update the displayed data.

Operation
7-95).
Operation
November 2017
(Figure
125