Inspection And Installation; To Inspect B1500 And Accessories - Keysight Technologies B1500A User Manual

Inspection and Installation

This section describes what to do when you receive the instrument and accessories.
1. Inspect the shipment. See
2. Verify the instrument operation and perform initial setup. See
Initial Setup".
3. Install the instrument in the appropriate place. See
To use the instrument briefly, see
To change the Windows logon setting, see
page 3-9.
To change the GPIB address of the instrument, see
page 3-10.
To allow the B1500A/EasyEXPERT to control external GPIB devices, see
Enable System Controller" on page

To Inspect B1500 and Accessories

Perform the following inspections when the instrument and accessories arrive at
your site.
1. Before unpacking any components, inspect all boxes for any signs of damage
that might have occurred during shipment, such as:
• dents
• scratches
• cuts
• water marks
If you suspect any damage, notify your local Keysight Technologies sales or
service office.
2. When you open the boxes that contain the instrument and accessories, check the
components against the contents lists attached to the boxes.
If anything is missing, notify your local Keysight Technologies sales or service
office.
Keysight B1500A User's Guide, Ed ition 14
"To Inspect B1500 and
"Getting Started" on page
"To Change Windows Logon Setting" on
"To Change GPIB Address" on
3-11.
Installation
Inspection and Installation
Accessories".
"To Perform
"Requirements" on page
1-1.
"To
3-4.
3- 7