Mounting Connectors - Keysight Technologies B1500A User Manual

WARNING

Mounting Connectors

Previous sections described how to install the available accessories, and Keysight
16495 Installation Guide provides the information on how to install connector
plates on the shielding box. However, you may choose to mount connectors directly
on your own connector plate or test fixture.
To do this, you will need to make connector holes and mount the connectors
yourself. This section contains information on connector hole dimensions.
To mount connectors:
1. Select and prepare the appropriate parts for your application. See
2. Make the holes and mount the connectors. See
For Kelvin connections (remote sensing), use Keysight 16493K Kelvin triaxial
cable. The Kelvin triaxial cable requires a Kelvin triaxial connector, which has
two connector holes and three screw holes.
3. Build the interlock circuit shown in
3-31.
4. Attach cables from the connectors to the DUT (device under test). See
Connect GNDU Output" on page
3-35, and "To Connect MFCMU Output" on page
For safety, prepare and attach a shield cover to avoid touching the joints on the
wiring side of connectors. And ground the cover.
Wrap an insulator around the naked conductors of coaxial cable to avoid
touching it.
Keysight B1500A User's Guide, Ed ition 14
Mounting Connectors
Table 3-6.
"To Make an Interlock Circuit" on page
3-34, "To Connect SMU Output" on page
3-42.
Installation
Table 3-5.
"To
3- 29