General - Silca Unocode 399 Plus Operating Manual

Unocode 399 PLUS
UNOCODE 399 PLUS has been designed in compliance to the European Community normative (CE).
From the design
Further risks have been eliminated by means of protective devices.
The materials used to manufacture this machine and all its components are not hazardous.
U
SE
UNOCODE 399 PLUS is designed for cutting keys of ferrous materials: brass, silver nickel, etc.
It must be installed and used according to the instructions indicated by the manufacturer.
If the key-cutting machine is used differently or for purposes different from those described in this manual, the customer will forego
any rights he may have over Silca S.p.A. Furthermore, unforeseen danger to the operator or any third parties may arise from
incorrect use of the machine.
I
NSTRUCTIONS MANUAL
The instructions manual provided with the machine is essential to its proper use and to carry out the
necessary maintenance.
We therefore recommend protecting the manual from damage in a safe sheltered place, easily to
hand for quick consultation.
I
NCORRECT USE
Operator negligence resulting in improper use of this machine or failure of the operator to observe the instructions written in this
manual. The manufacturer may decline all guarantees and responsibilities.
It is therefore essential to carefully read this operating manual.
F
URTHER RISKS
No further risks will arise when properly using the UNOCODE 399 PLUS.
P
ROTECTION AND SAFETY PRECAUTIONS FOR THE OPERATOR
UNOCODE 399 PLUS is entirely built in compliance to the Machine Directives. The operations for which it has been
designed are easily carried out with no risk to the operator.
The adoption of general safety precautions and observation of the instructions provided by the manufacturer in this manual
eliminate all human error, unless deliberate.
UNOCODE 399 PLUS is designed with features which make it completely safe.
Power supply
•
UNOCODE 399 PLUS is supplied with electricity by means of a grounded plug and differential switch.
Pneumatic power
•
With compressed air.
Start-up
•
The machine is turned on by means of a master switch that is located on the Unocode's lower left back side.
Maintenance
•
The operations to regulate, service, repair and clean the machine are structured in the simplest and safest way possible. Parts that
the operator can dismount cannot be incorrectly replaced therefore avoiding any risks.
2

GENERAL

stage, risks for the operator have been eliminated in all areas: transport, regulation, cutting and maintenance.
Copyright Silca 2016
Operating manual - English