Silca Unocode 399 Plus Operating Manual page 52

Unocode 399 PLUS
Press START, the display will show:
Press ENTER to confirm, only if the previous
parameters were ON (***).
Press STOP to cancel the operation and not
confirm the adjustments made (if there is one value
or more on OFF). The previous values remain valid
(already in the machine's memory).
ATTENTION:
will be lost. If so, only the previous setting values will remain
valid.
(**) If the templates have not been properly
positioned the following ERROR message appears:
(***) If one or both the photocells or one or both the sensors are OFF, repeat the operation following
the procedure described in chap. 5.8.8, page 49.
48
if the STOP key is pressed, the new settings
Copyright Silca 2016
Operating manual - English