General - Silca Unocode PRO Operating Manual

UNOCODE PRO
UNOCODE PRO has been designed in compliance to the European Community normative (CE).
From the design stage, risks for the operator have been eliminated in all areas: transport, regulation, cutting and mainte-
nance.
Further risks have been eliminated by means of protective devices.
The materials used to manufacture this machine and all its components are not hazardous.
U
SE
UNOCODE PRO is designed for cutting keys of ferrous materials: brass, silver nickel, etc.
It must be installed and used according to the instructions indicated by the manufacturer.
If the key-cutting machine is used differently or for purposes different from those described in this manual, the customer
will forego any rights he may have over Silca S.p.A. Furthermore, unforeseen danger to the operator or any third parties
may arise from incorrect use of the machine.
I
NSTRUCTIONS MANUAL
The instructions manual provided with the machine is essential to its proper use and to carry out the necessary mainte-
nance.
We therefore recommend protecting the manual from damage in a safe sheltered place, easily to hand for quick consul-
tation.
I
NCORRECT USE
Operator negligence resulting in improper use of this machine or failure of the operator to observe the instructions written
in this manual. The manufacturer may decline all guarantees and responsibilities.
It is therefore essential to carefully read this operating manual.
I
MPROPER USE OF ELECTRIC CONTACT
• it is not permitted to cut ultralite anodized aluminium keys, plastic keys or any keys with materials that do not
have electrical conductivity by means of electric contact.
• cuts cannot be repeated on the same side of the key when electric contact cutting is used.
F
URTHER RISKS
The UNOCODE PRO machine has residual risks in the highlighted area
shown in fig. 2.
P
ROTECTION AND SAFETY PRECAUTIONS FOR THE OPERATOR
UNOCODE PRO is entirely built in compliance to the Machine Directives. The operations for which it has been designed
are easily carried out with no risk to the operator.
The adoption of general safety precautions and observation of the instructions provided by the manufacturer in this
manual eliminate all human error, unless deliberate.
UNOCODE PRO is designed with features which make it completely safe.
• Power supply
UNOCODE PRO is supplied with electricity by means of a grounded plug and differential switch.
• Pneumatic power
With compressed air.
• Start-up
The machine is turned on by means of a master switch that is located on the Unocode's lower left back side.
• Maintenance
The operations to regulate, service, repair and clean the machine are structured in the simplest and safest way possible.
Parts that the operator can dismount cannot be incorrectly replaced therefore avoiding any risks.
2

GENERAL

Copyright Silca 2017
Operating manual - English
Fig. 2