Silca Unocode 399 Plus Operating Manual page 31

Operating manual - English
d) Data Card Parameters
Function used to view the technical data
relating to the data card.
• Press F4.
• Press F1.
• Press STOP to exit.
(*) With the measuring unit set on millimetres the highlighted measurements are expressed in
hundredths of a millimetre.
Key blank measurements *
Cutting angle
Symbols associated to cutting depths *
Cutting spaces *
Measuring unit
Base of the cuts *
Copyright Silca 2016
F4
F1
Key stop
Unocode 399 PLUS
27