Messages; Attention Messages - Silca Unocode 399 Plus Operating Manual

Unocode 399 PLUS
5.11 M
ESSAGES
5.11.1 A
TTENTION MESSAGES
• The entered data card number is not available in the machine's data base.
• The entered cuts cannot be carried out (see chap.5.4, page 31).
• This message appears when the cutter must be changed with one that is compatible to the type of cuts required for the
entered data card number.
• This clamp is not available in the machine's data base.
• This cutter is not available in the machine's data base.
• This adapter is not available in the machine's data base.
• The entered data card number requires a type of cut that is not available in the machine's data base.
• The minimum distance from the key stop position overlaps the first cut on the key (chap.5.9, page 52).
56
Data card
not available!
Non-feasible
combination!
ATTENTION!!
Install cutter:
U01W
Clamp not
available!
Cutter not
available!
Adaptor not
available!
Type of cut
not available!
MIN. Parameter of
DISTANCE FROM STOP
is incompatible with
selected card!
Copyright Silca 2016
Operating manual - English