Silca Unocode 399 Plus Operating Manual page 61

Operating manual - English
• During the cutting cycle one or more depth exceeded the maximum limit. These depths are automatically aligned to the
maximum permitted depth.
• Indicates that the entered function is not yet available.
• This message appears when the calibration data are not on the machine.
• This message appears when the data are not compatible with the data structure.
• This message appears when axis clearance has not been successful.
• Indicates that the adjustments inserted can only be applied to the two cases and not to Copy from original.
• This message appears if you wish to reset the machine on the initial settings, i.e. with the default parameters set up by Silca
(see chap.5.9, page 52).
ATTENTION
Depth limit
exceeded!
Non-feasible
function !
Jaw
not calibrated !
Data format
not compatible!
See operating manual
Zero point axis
Movement
not completed!
Modifications are only
applied to COPY BY CARD
and COPY WITH
ADJUSTMENTS
Resetting of original machine data Con-
firm operation?
No=STOP Yes=ENTER
Copyright Silca 2016
Unocode 399 PLUS
57