Setting Network Parameters Manually - Fronius TPS 320i Operating Instructions Manual

Setting network
parameters man-
ually
1
2
3
The network setup overview is displayed.
If DHCP is enabled, the IP address, Network mask and Standard gateway network param-
eters are greyed out and cannot be adjusted.
4
5
DHCP is disabled, the network parameters can now be set.
6
7
The numerical pad for the selected parameter is displayed.
8
9
The value for the network parameter is applied, the network setup overview is displayed.
10
144
3
1
Select "Defaults"
Select "System"
Select "Network Setup"
Turn the adjusting dial and select "DHCP"
Press the adjusting dial
Turn the adjusting dial and select the desired network parameter
Press the adjusting dial
Enter a value for the network parameter
Select "OK" and confirm the value for the network parameter / press the adjusting dial
Select "Store" to apply changes to the network setup
2