Process Parameters For Correction Limits - Fronius TPS 320i Operating Instructions Manual

Limit monitoring
(only in conjunction with the OPT/i Limit Mon-
itoring option)
-
-
-
-
-
-
-
-
-
-
-
-
-
Components
-
Further information on optimising jobs can be found in the Welding mode section, under
Job Mode on page 85.
Process parame- The following process parameters can be set for the job correction limits:
ters for correction
limits
Power
Upper power correction limit
For setting the upper power correction limit for a job
Unit
Setting range
Factory setting
Lower power correction limit
For setting the lower power correction limit for a job
Unit
Setting range
Factory setting
Arc length correction
Upper arc length correction limit
For setting the upper arc length correction limit for a job
Unit
Setting range
Factory setting
Voltage set value
Lower voltage limit
Upper voltage limit
Max. duration of voltage deviation
Current set value
Lower current limit
Upper current limit
Max. duration for current deviation
Wire speed set value
Lower wire speed limit
Upper wire speed limit
Max. duration of wire stick deviation
Response to violation of limit values
Feeder inching speed
%
0 - 20
0
%
-20 - 0
0
-
0.0 - 10.0
0
See page 128
See page 117
127