Process Parameters For Wire Stick Work Piece - Fronius TPS 320i Operating Instructions Manual

7
Process parame-
ters for wire stick
work piece
1
2
An overview of the process parameters for components and monitoring is displayed:
122
The welding process will be interrupted in the event of wire stick on the contact tip.
IMPORTANT! Monitoring is only possible during dip transfer arc processes.
Factory setting = ignore
Filter time = 0.5 - 5.0 s
Maximum duration without arc short circuit until welding is interrupted.
Factory setting = 0.5 s
Select "OK" to confirm the settings
1
Select "Process parameters"
Select "Components & Monitoring"
3
2