Process Parameters For "Save As Job" Pre-Settings - Fronius TPS 320i Operating Instructions Manual

Lower arc length correction limit
For setting the lower arc length correction limit for a job
Unit
Setting range
Factory setting
Further information on optimising jobs can be found in the Job correction limits section, un-
der Job Mode on page 86.
Process parame- After confirming the displayed information, the following process parameters can be set for
ters for "Save as the "Save as Job" pre-settings:
Job" pre-settings
Jobslope - Pre-settings
Jobslope
Defines the time between the job that is currently selected and the next job
Unit
Setting range
Factory setting
Limit monitoring - Pre-settings
(only in conjunction with the OPT/i Limit Monitoring option)
Lower voltage limit
For setting the lower voltage limit as a function of the set value
Unit
Setting range
Factory setting
Upper voltage limit
For setting the upper voltage limit as a function of the set value
Unit
Setting range
Factory setting
Maximum duration of voltage deviation
For setting the maximum duration of a voltage deviation
Unit
Setting range
Factory setting
Lower current limit
For setting the lower current limit as a function of the set value
Unit
Setting range
Factory setting
128
-
-10.0 - 0.0
0
s
0.0 - 10.0
0
V
-10.0 - 0.0
0
V
0.0 - 10.0
0
s
off / 0.1 - 10.0
off
A
-100.0 - 0.0
0