Setting Process Parameters For Arc Break Monitoring - Fronius TPS 320i Operating Instructions Manual

3
If system calibration is required, the system calibration wizard starts. The first step in the
system calibration wizard is displayed:
4
5
When system calibration has been completed successfully, a confirmation to this effect is
displayed.
6
Setting process
parameters for
arc break moni-
toring
1
2
Select "system adjust"
Follow the displayed instructions
To move to the next step in the wizard, select "Next" / press the adjusting dial
To close the system calibration wizard, select "Finish" / press the adjusting dial
1
Select "Process parameters"
Select "Components & Monitoring"
3
2
119