Welding Parameters For Mig/Mag Standard Synergic Welding And Lsc Welding - Fronius TPS 320i Operating Instructions Manual

Welding parame- The following welding parameters for MIG/MAG standard synergic welding and LSC weld-
ters for MIG/MAG ing can be set and displayed by selecting the "Welding" menu button:
standard syner-
gic welding and
Current
LSC welding
Unit
Setting range
Before the start of welding, the device automatically displays a standard value based on
the programmed parameters. During welding, the actual value is displayed.
Voltage
Unit
Setting range
Before the start of welding, the device automatically displays a standard value based on
the programmed parameters. During welding, the actual value is displayed.
Material thickness
Unit
Setting range
Feeder command value
for setting a harder, more stable arc
Unit
Setting range
Arc length correction
For correcting the arc length, which is preset by the characteristic or the synergic pro-
gram;
Setting range
Factory setting
-
0
+
Pulse/dynamic correction
For influencing the short-circuiting dynamic at the instant of droplet transfer
Setting range
Factory setting
-
0
+
1)
A
Depends on the welding process and welding program selected
1)
V
Depends on the welding process and welding program selected
1)
mm
0.1 - 30.0 mm
1)
m/min
0.5 -max.
-10 - +10
0
Shorter arc length
Neutral arc length
Longer arc length
-10 - +10
0
Harder, more stable arc
Neutral arc
Soft, low-spatter arc
in.
2) 2)
0.004 - 1.18
ipm.
2) 2)
19.69 -max.
75