Epson RC90 User Manual page 136

Maintenance 9. Troubleshooting
No. Message
Cannot execute while the maximum
1032
number of tasks are executing.
Cannot execute during asynchronous
1033
motion command.
Asynchronous
1034
during operation.
Cannot execute when Remote I/O
1035 enabled except from the remote
device.
Cannot execute when OP enabled
1036
except from the OP.
Cannot execute when Remote Ethernet
1037 enabled except from the remote
Ethernet device.
1039 Execution is prohibited.
Cannot execute during Emergency
1041
Stop status.
Cannot execute while the safeguard is
1042
open.
1043 Cannot execute during error condition.
Cannot execute when the remote pause
1044
input is ON.
Input waiting condition is the only
1045
available condition to input.
1046 Cannot execute during file transfer.
Cannot cancel the command executed
1047
from other devices.
Cannot execute after low voltage was
1048
detected.
1049 Other devices are in program mode.
1050 Password is too long.
1051 Export Controller Status failed.
1052 Export Controller Status busy.
1053 Cannot execute in TEST mode.
Cannot execute in TEST mode except
1054
from TP.
1055 Cannot execute the Background Task.
1100 File failure. Cannot access the file.
File failure. Read and write failure of
1102
the registry
1103 File is not found.
1104 Project file was not found.
1105 Object file was not found.
1106 Point files were not found.
The program is using a feature that is
1107 not supported by the current controller
firmware version.
One or more source files are updated.
1108
Please build the project.
1109 Not enough storage capacity.
1110 File is not found.
1111 Conveyor file was not found.
120
Stop the task and then execute.
Execute after the motion ends.
The asynchronous command already
command stopped
stopped when the controller received a
stop command.
-
-
Cancel the Emergency Stop status.
Close the safeguard.
Cancel the error condition.
Change the remote pause input to OFF.
The controller received an input while it
was not in the Input waiting condition.
Execute after the file transmission.
Cancel the motion command from the
device the command was issued from.
Check whether the file exists.
Rebuild the project.
Rebuild the project.
Rebuild the project.
Rebuild the project.
Increase free space of the USB memory.
Remedy
RC90 (EPSON RC+ 7.0) Rev.4
Note 1 Note 2