Epson RC90 User Manual page 212

Maintenance 9. Troubleshooting
No.
10000 Command aborted by user
10001 Command timeout.
10002 Bad point file line syntax
10003 Project could not be built.
10004 Cannot initialize Spel class instance.
10005 Cannot initialize parser.
10006 Cannot initialize wbproxy.
10007 Project does not exist.
10008 No project specified.
10009 Cannot open file.
10010 Cannot create file.
10011 File not found
Cannot execute LoadPoints with Robot
10013
Manager open.
Project cannot be locked. It is being used
10014
by another session.
10015 Project could not be synchronized.
10016 Drive not ready
10017
Invalid IP address
10018
Invalid IP mask
10019
Invalid IP gateway
IP address or gateway cannot be the subnet
10020
address.
IP address or gateway cannot be the
10021
broadcast address.
10022
Invalid DNS address
Commands cannot be executed because
10023
the project build is not complete.
10024 Invalid task name.
10100 Command already in cycle.
10101 Command aborted by user.
10102 Invalid server instance.
10103 Invalid CommandTask value.
Cannot change
10104
initialized.
10501 Connection aborted.
10502 Cannot connect with the controller.
Controller firmware is not compatible with
10503
this version of RC+.
USB connection of this system is reserved
10504 for the RC620 Controller and cannot be
used for RC+7.0.
10505 The specified connection does not exist.
10600 Frame grabber driver not installed.
196
Message
ServerInstance after
Remedy
Check whther the project name and
the path are correct.
Specify the project.
Check whether the project name
and the path are correct.
Check whether the project name
and the path are correct.
Close the robot manager and
execute.
Terminate other applications.
Check whether the
designation is correct.
Check the IP address.
Check the IP mask.
Check the IP gateway.
Check the IP address.
Check the IP address.
Check the DNS.
Execute after the project build is
completed.
Check the task name.
Specify the correct instance.
Specify the correct task number.
Set ServerInstance
initialization.
Upgrade the RC+ version.
Install the RC+7.0 to another
computer.
Check the connection number.
Install the driver.
Note 1
drive
before
RC90 (EPSON RC+ 7.0) Rev.4
Note 2