Epson RC90 User Manual page 8

Before Reading This Manual
Do not connect the followings to the TP/OP port of RC90. Connecting to the followings
NOTE

may result in malfunction of the device since the pin assignments are different.
OPTIONAL DEVICE dummy plug
Operation Pendant OP500
Operator Pendant OP500RC
Jog Pad JP500
Teaching Pendant TP-3**
Operator Panel OP1
NOTE
For RC90, be sure to install the EPSON RC+ 7.0 to the development PC first, then connect

the development PC and RC90 with the USB cable.
If RC90 and the development PC are connected without installing the EPSON RC+ 7.0 to
the development PC, [Add New Hardware Wizard] appears. If this wizard appears, click
the <Cancel> button.
Concerning the security support for the network connection:
NOTE

The network connecting function (Ethernet) on our products assumes the use in the local
network such as the factory LAN network. Do not connect to the external network such
as Internet.
In addition, please take security measure such as for the virus from the network connection
by installing the antivirus software.
Security support for the USB memory:
NOTE

Make sure the USB memory is not infected with virus when connecting to the Controller.
vi RC90 (EPSON RC+ 7.0) Rev.4