Overview Of The Ssu-2000E Security System - Symmetricom SSU-2000e User Manual

ICS commands:
Type
IP ADDR [ip address]
Type
IP GATEWAY [gate address]
Type
IP SUBNET [subnet address]
TL1 command:
SET-PRMTR-IP:::123::[ip address],[gate address],[subnet address];
3. Restart the Communications module:
ICS command:
Type
restart 1A02
TL1 command:
RST-MODULE::S1A2:123;
4. Verify that the information is correct:
ICS command:
Type , then press Enter.
ip
TL1 command:
RTRV-PRMTR-IP:::123;
Connecting through the Ethernet LAN
After the Ethernet port is configured, use the following procedure to connect to it:
1. Ensure that the SSU-2000e is connected to a LAN. See
Connections, on page 65 for details.
2. Telnet from your PC to the IP address assigned to the SSU-2000e.
3. Type your user name and press the Enter key. If you are not assigned as a user
in the system, contact the System Administrator for your SSU-2000e.
4. Enter your assigned password and press Enter. The system prompt appears.

Overview of the SSU-2000e Security System

The operating software of the SSU-2000e includes a subset of GR-815 security
requirements, including user lockout, password aging, and login failure attempts.
New commands allow an Administrator-level user to query the security log, set the
login failed attempts threshold, set user lockout timer, and set the password-aging
timer. New commands also allow you to back up and restore the configuration in the
shelf. See the SSU-2000e Technical Reference for details on the security
commands.
12713140-002-2 Revision E – October 2006
Chapter 3 Provisioning and Operating the SSU-2000e
, then press Enter.
, then press Enter.
, then press Enter.
, then press Enter.
Overview of the SSU-2000e Security System
Making Ethernet
SSU-2000e User's Guide 93