Adding An Administrator User - Symmetricom SSU-2000e User Manual

Table 3-3. User Access Levels
Level ID
Idle 0 Access level 0 is available when no user is logged in. This level allows
Idle-level users to view a list of available commands (HELP), syntax, software
version number, unit id, or to login.
User 1 Users at the User level can execute level 0 commands and view information
about the current configuration and operation, and change communication
settings such as line termination and echo. Changes made by a User-level
user remain in effect only until the user logs out.
Technician 2 Users at the Technician level (CRAFT persons) can perform levels 0 through 1
functions, and can read or set all installation functions.
Supervisor 3
can read or set all functions.
Administrator 4 Administrator-level users can execute all levels of commands; they can view
and set software configurations; they can also add, delete, or modify the user
table, or log off any user from any port.

Adding An Administrator User

You must add an Administrator-level user to the user list when you log in for the first
time. The Administrator user performs initial setup and can assign user privileges
and access codes as needed, as well as configure all system parameters
Overview of the SSU-2000e Security
user access levels.
Caution: You must add the administrator user and password before
adding any other users. If you add a user that is not at the
administrator security level before adding the administrator, you will
not be able to log into the unit at that level again without a service call.
Perform the following steps to add an Administrator-level user to the system.
1. Connect a computer to the SSU-2000e using the procedure in
by Serial
2. Type
admin
enter your username) and press Enter. The system prompts for a password.
3. Press the Enter key for the first-time system login (otherwise enter your
password and press Enter). The system prompt appears.
4. Type
user add
12713140-002-2 Revision E – October 2006
Supervisor-level users can execute all commands at levels 0 through 2, and
Port, on page 91. The
at the username prompt for the first-time system login (otherwise
and press Enter. The system prompts you for a username.
Chapter 3 Provisioning and Operating the SSU-2000e
Description
System, on page 93, for more information on
prompt appears.
SSU-2000e>
Adding An Administrator User
Refer to
.
Communicating
SSU-2000e User's Guide 95