Ssu-2000E System Components - Symmetricom SSU-2000e User Manual

Table 9-1. SSU-2000e System Components
Item Description
1 SSU-2000e Main Shelf
(Chassis) with SDU
termination plug and
SSU-2000e
Synchronization Supply
Unit User Guide
2 Bracket, rack ear,
530mm
3 Bracket, rack ear,
480mm
4 Stratum 2E Rb Clock
module
5 3E Clock module
6 Type I Clock module
12713140-002-2 Revision E – October 2006
Part Number
SSU-2000e Main Shelf and Associated Hardware
25413140-000-0
00413140-001-1-2
00413140-000-1
Clock Modules
23413016-000-0
23413015-000-0
23413015-001-0
Chapter 9 Hardware Configuration Guide
SSU-2000e Configuration Chart
Notes
Required for all systems.
If an expansion chassis (SDU-2000e) is
not attached to J8, an SSU Expansion
Terminator, P/N 12013049-000-0 must be
installed on the SSU-2000e chassis,
connector J8. Otherwise, the terminator
must be installed on the last expansion
chassis in the system.
Requires minimum of one Comms
module, one Clock module, one Input
module, one Output module, and eight
filler panels (including one wide panel).
Two each provided with the main shelf.
Two each required per main shelf (must
specify 23" rack).
1. Minimum of one Clock module per
system (item 4, 5, or 6).
2. Redundant configuration with
automatic switching in case of clock
failure requires two Clock modules.
3. The system will operate with 2E, 3E,
or Type I clocks combined. 2E clock
should be installed in chassis slot A1.
1. Minimum of one Clock module per
system (item 4, 5, or 6).
2. Redundant configuration with
automatic switching in case of clock
failure requires two Clock modules.
3. The system will operate with 2E, 3E,
or Type I clocks combined. 2E clock
should be installed in chassis slot A1.
1. Minimum of one Clock module per
system (item 4 or item 5).
2. Redundant configuration with
automatic switching in case of clock
failure requires two Clock modules.
3. The system will operate with 2E, 3E,
or Type I clocks combined. 2E clock
should be installed in chassis slot A1.
SSU-2000e User's Guide 229