Disabling A Module - Symmetricom SSU-2000e User Manual

Chapter 2 Installing the SSU-2000e
Handling Modules
ICS command:
Type
CONFIG 1A3 DISABLE
TL1 command:
DISC-MODULE::S1A3:123;
4. Loosen the captive screws located at the top and bottom of the module front
panel.
5. Pull up on the top extractor and down on the bottom extractor to unseat the
module from the connector on the backplane.
6. Slide the module out of the shelf.
7. Insert the new module into slot 3 of the main shelf. Tighten the captive screws
on the front panel of the module. Wait for the "
appear.
Note: Be sure that the I/O Adapter port is of the proper type and
impedance for the new module.
Caution: To avoid possible damage and intermittent failures, ensure
that you have completely inserted the module into the system and
that you have securely tightened the captive screws.
8. Enable the module using either TL1 or ICS commands:
ICS command:
Type
CONFIG 1A3 ENABLE
TL1 command:
ACT-MODULE::S1A3:123;
9. Verify that the module is entered in the registry:
ICS command:
Type
CONFIG
TL1 command:
RTRV-INV:::123;

Disabling a Module

Use this command to temporarily disable a module without removing it from the
SSU-2000 registry. All outputs from the disabled module will turn off, unless a
summer adapter is installed on the I/O connector on the rear panel of the shelf. The
example commands are for slot 3 in the main shelf.
76 SSU-2000e User's Guide
, then press Enter.
, then press Enter.
, then press Enter.
" message to
module installed
12713140-002-2 Revision E – October 2006