Status Led Indicators - Symmetricom SSU-2000e User Manual

DS1 Input Module Events Reported
The 3-Port DS1 Input module reports the event types listed in
occur:
Table 7-6. DS1 Input Module Event Reporting
Event
Card installed
Card enabled
Card disabled
Card restarted
Input Signal Episode,
Alarm, and Faults
Hardware Faults
Received SSM
Changed
Phase Buildout
Configuration Changes
Input phase zeroed

Status LED Indicators

The DS1 Input module is equipped with eight status LEDs that indicate module
status. These LEDs are shown in
12713140-002-2 Revision E – October 2006
Parameter One
–
–
–
Delay before restart (in Seconds)
–
–
New PQL
Phase value being built out
New Value (if necessary)
–
Figure 7-4
Chapter 7 Input Module Reference Data
1-Port and 3-Port DS1 Input Modules
Table 7-6
Parameter Two
–
–
–
–
–
–
Old PQL
Corrected phase value
Old Value (if not implied by new
value)
–
and are described in Table
SSU-2000e User's Guide 179
when they
7-7.