Ssu-2000E Input Connector Scheme - Symmetricom SSU-2000e User Manual

Table 1-2. Clock Input Connector to Input Module Relationship (Continued)
Slot
Label
(Name)
INPUT-2
INPUT-3
The Load and Input connectors are cross-wired as four wire, east-west connections.
The Input connectors are used to connect the clock reference inputs to the
associated input ports on the installed Input modules. Termination plugs are
available to install in the load connectors if the reference signal is to be terminated.
The Monitor connectors are connected as 20 dB monitors to each attached clock
reference input signal, as shown in
Figure 1-9.

SSU-2000e Input Connector Scheme

Output Clock Connectors
The SSU-2000e connector panel contains three groups of 20 summed output clock
connectors. The groups are labeled OUTPUT GROUP 1 that are installed in A6 and
A7, OUTPUT GROUP 2 that are installed in A8 and A9, and OUTPUT GROUP 3
that are installed in A10 and A11. See
12713140-002-2 Revision E – October 2006
Plug-in Module
Module Input
Slot Port
A4 1
2
3
A5 1
2
3
Connector Reference Description
Monitor
J19 J20
J22 J23
J25 J26
J28 J29
J31 J32
J34 J35
Figure 1-9.
Table 1-3 for additional information.
Chapter 1 Product Overview
System Components
Load Input
J21
J24
J27
J30
J33
J36
SSU-2000e User's Guide 35