Agilent Technologies E8362A Service Manual page 276

Repair and Replacement Procedures
Removing and Replacing the A41 Hard Disk Drive
Removal Procedure
1. Disconnect the power cord.
Removing the HDDA
Refer to Figure 7-29
1. With a T-10 TORX driver, loosen the four HDDA mounting screws (item
panel.
2. Remove the HDDA from the analyzer by pulling on the finger grip (item
interconnects with a connector inside the analyzer rear panel so moderate force may be
necessary to disengage this connector.
Figure 7-29 Hard Disk Drive Assembly Removal
7-62
for this procedure.
PNA Series Microwave Network Analyzers
E8362A, E8363A, E8364A
①
) on the rear
②
). The HDDA
Service Guide E8364-90001