PNA Series Microwave Network Analyzers
E8362A, E8363A, E8364A
Disassembling the HDDA
When replacing the hard disk, first torque all four screws (item ③) to 4 in-lb,
IMPORTANT
then secure each to 7 in-lb with a T-10 TORX driver.
Refer to
Figure
7-30.
1. Remove the hard disk drive assembly from the analyzer. Refer to
on page
7-62.
2. With a T-10 TORX driver, remove the four screws (item
②
(item
), that mount the hard disk (item
3. Disconnect the hard disk (item
Figure 7-30 Hard Disk Drive Assembly (Exploded View)
Service Guide E8364-90001
Removing and Replacing the A41 Hard Disk Drive
④
), to the bracket.
④
) from the interface board (item
Repair and Replacement Procedures
"Removing the HDDA"
①
), and the eight bushings
③
).
7- 63