Agilent Technologies E8362A Service Manual page 26

General Product Information
Required Service Test Equipment
a
Equipment
Extender board
T-8 TORX driver
T-10 TORX driver
T-20 TORX driver
1/4-inch and 5/16-inch
open-end wrench
5/16-inch, open-end
torque wrench (metric
equivalent is 8 mm)
1-inch, open-end torque
wrench (metric
equivalent is 26 mm)
20-mm, open-end torque
wrench
Adjustable antistatic
wrist strap
Antistatic wrist strap
grounding cord (5 foot)
Static control table mat
and earth ground wire
Floppy disks
a. Unless specified otherwise, equipment listed is required for all analyzer models.
b. P = Performance tests, A = Adjustments, T = Troubleshooting, R = Repair, V = System verification
2-8
Critical Specifications
Tools
N/A
0.6 N-m (5 in-lb) setting
0.5, 0.8, and 1.0 Nm
(4, 7, and 9 in-lb) settings
2.4 N-m (21 in-lb) setting
Thin profile
1.1 and 2.4 Nm
(10 and 21 in-lb) settings
(for semi-rigid cables)
8.1 N-m (72 in-lb) setting
(for Port 1 and Port 2
connector nuts)
0.9 N-m (8 in-lb) setting
(for Port 1 and Port 2
measurement connections)
Static Safety Parts
N/A
N/A
N/A
Miscellaneous
3.5 inch
PNA Series Microwave Network Analyzers
E8362A, E8363A, E8364A
Recommended Alternate
Model or Part Model
Number Number
E8356-60021 None
N/A N/A
N/A N/A
N/A N/A
8710-0510 N/A
N/A N/A
N/A N/A
N/A
8710-1764
9300-1367 None
9300-0980 None
9300-0797 None
Any None
Service Guide E8364-90001
b
Use
T
R
T,R
T,R
A,R
T,R
R
P,A,T
P,A,T
P,A,T
P,A,T
A