B. Luminescence Data - Promega E8051 Technical Manual

Glomax multi+ detection system
Table of Contents

Advertisement

15.B. Luminescence Data

Luminescence data is displayed in Relative Luminescence Units (RLU).
Kinetics
Kinetic results are displayed as a graphic curve in the Results screen. To obtain
numeric readings, export the results file to a USB flash drive and transfer it to
a computer. See Section 15.F for transferring data. There will be a single results
file for the entire run.
The X axes are displayed in linear time, and Y axes are displayed in log RLU
scale. The Y axes have a minimum range of 1 log (a result value range of 10).
Each well auto-adjusts to display the graph in full Y-axis scale.
Ratio Readings
When two injectors are used in a protocol, two readings are taken for each
sample. Results are displayed side-by-side in the corresponding well (partial
view) or first reading on top of the second reading (full view). To view a ratio
of the two readings, touch the "Ratio" button. The ratio calculated for
luminescence data is different than the ratio calculated for absorbance data.
The luminescence ratio is calculated as:
1st Reading
Ratio =
2nd Reading
Note: A value of 1 × 10
15.C. Absorbance Data
Single wavelength absorbance data can be displayed in three different units:
Optical Density (OD), Percent Transmittance (%T) and Percent Absorbance
(%A). Data exported to .csv format is only in OD units. To view the different
units in the Results screen, toggle the button corresponding to the unit type.
Data calculations:
Transmittance (T) =
%T = 100T
OD = –log
(A)
10
Absorbance = 2 – log
I is the light intensity at a specific wavelength that has passed through the
sample. I
is the light intensity before it enters the sample.
0
Note: The maximum OD value of 5.0 means there was zero transmittance.
Promega Corporation · 2800 Woods Hollow Road · Madison, WI 53711-5399 USA
Toll Free in USA 800-356-9526 · Phone 608-274-4330 · Fax 608-277-2516 · www.promega.com
Printed in USA.
Revised 5/10
29
indicates saturation of the luminescence signal.
I
I
0
(%T)
10
Part# TM311
Page 49

Advertisement

Table of Contents
loading

This manual is also suitable for:

E8031E8041E8061E9061E9031

Table of Contents