Table of Contents
Advertisement
16.D. Installing Microsoft .NET Framework version 2.0 (x86)
The following steps are necessary only if Framework software is not already
installed on the computer. Perform either step one or step two.
1. Insert the External PC Connect software CD into the PC. View the files on
the CD, and double-click on the file "dotnetfx.exe." Follow the step-by-step
instructions to install the software.
2. Alternatively, download .NET from this web site:
www.microsoft.com/downloads/
16.E. Installing the Drivers for the GloMax
When connecting to a PC through a USB cable for the first time, the computer
will detect the instrument as a new device. The drivers necessary to connect to
the instrument are included with the PC version of the software. Follow the
instructions below to install the drivers. The following example is based on
using the Windows
1. Install the software onto the PC.
2. Connect the GloMax
cable. Use the USB port on the back panel of the instrument. The USB port
on the front of the instrument is used only for data transfer.
3. Turn on the GloMax
4. The "Found New Hardware" wizard will appear. Follow the step-by-step
instructions below to complete the wizard.
5. Select: "No, Not This Time" on
the Welcome screen, then select
the "Next" button to continue.
Promega Corporation · 2800 Woods Hollow Road · Madison, WI 53711-5399 USA
Toll Free in USA 800-356-9526 · Phone 608-274-4330 · Fax 608-277-2516 · www.promega.com
Printed in USA.
Revised 5/10
®
-Multi+ Detection System
®
XP operating system.
®
-Multi+ Detection System to the PC using the USB
®
-Multi+ Detection System.
Part# TM311
Page 53
Advertisement
Table of Contents
