Table of Contents
Advertisement
6.B. Modifying a Saved Protocol
1. From the Home screen, touch the "Instrument Control" button, then touch
the "Read" button (Figure 9).
Figure 9. Modifying a Saved Protocol screen.
2. Touch the "Protocol Name" button to call up the Preset and User protocol
window.
3. Select a protocol from the list of Preset or User-modified choices and touch
the "OK" button.
4. To modify the desired parameter(s), touch the white numeric button next
to the parameter label. Make the desired change then touch the "OK"
button.
5. Touch the "Plate" button and select the wells to be read. Green indicates
that a well is selected.
6. To run the modified protocol under the current name, touch the "Start"
button.
Use the "Delete" button to permanently remove
unwanted protocols from the User protocol list.
Well selections are linked to a protocol.
!
Before running any protocol, always verify the wells to be read.
Promega Corporation · 2800 Woods Hollow Road · Madison, WI 53711-5399 USA
Toll Free in USA 800-356-9526 · Phone 608-274-4330 · Fax 608-277-2516 · www.promega.com
Part# TM311
Page 16
Printed in USA.
Revised 5/10
Advertisement
Table of Contents
