Show Ipv6 Nd; Config Ipv6 Nd Ns Ipif System - D-Link DES-1210-52/ME Cli Reference Manual

Example usage:
To show all neighbor cache entries on the switch:
DES-1210-52/ME:5# show ipv6 neighbor_cache ipif all all
Command: show ipv6 neighbor_cache ipif all all
IPv6 Address
------------
Total Entries: 0
DES-1210-52/ME:5#

show ipv6 nd

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To show IPv6 ND related configuration:
DES-1210-52/ME:5# show ipv6 nd
Command: show ipv6 nd
Interface Name
NS Retransmit Time
DES-1210-52/ME:5#

config ipv6 nd ns ipif System

Purpose
Syntax
Description
Parameters
DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
Link-layer Addr
----------------------
Used to display information regarding neighbor detection on the
switch.
show ipv6 nd
This show ipv6 nd command is used to display information
regarding neighbor detection on the switch.
None.
None.
: System
: 1(ms)
Configures the IPv6 ND neighbor solicitation retransmit time，which
is the time between the retransmission of neighbor solicitation
messages to a neighbor, when resolving the address or when
probing the reachability of a neighbor.
config ipv6 nd ns ipif System retrans_time <integer 1-3600>
This show ipv6 neighbor_cache command is used to configures
the retransmit time of IPv6 ND neighbor solicitation
retrans_time <integer 1 - 3600> – Neighbor solicitation's retransmit
timer in milliseconds. It has the same value as the RA retrans_time
in the config IPv6 ND RA command. If the retrans_time parameter is
configured in one of the commands, the retrans_time value in the
other command will also change so that the values in both
commands are the same. The range if 1 to 3600.
State Interface
-------- ---------------
340