Download/Upload Commands; Download - D-Link DES-1210-52/ME Cli Reference Manual

The Download/Upload commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command

download

upload
config configuration
config_id
show firmware
information
show config
show boot_file
config firmware
image_id
Each command is listed in detail, as follows:
download
Purpose
Syntax
Description
Parameters
DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide

DOWNLOAD/UPLOAD COMMANDS

Parameter
[cfg_fromTFTP [<ipaddr> | <ipv6_addr>] <path_filename 64> config_id <value 1-
2>] | [firmware_ fromTFTP [<ipaddr> | <ipv6_addr>] <path_filename 64>
image_id <value 1-2>]
[[firmware_toTFTP [<ipaddr> | <ip6_addr>] <path_filename 64> image_id <value
1-2>] | [cfg_toTFTP [<ipaddr> | <ip6_addr>] <path_filename 64> config_id <value
1-2>] | [log_toTFTP [<ipaddr> | <ip6_addr>] <path_filename 64>]]
<value 1-2> [boot_up | delete]
[current_config | config_in_nvram config_id <value 1-2> {[begin | exclude |
include] <string 80>}
<value 1-2> [boot_up | delete]
To download and install a firmware, boot, or switch configuration file
from a TFTP server.
download [cfg_fromTFTP [<ipaddr> | <ipv6_addr>]
<path_filename 64> config_id <value 1-2>] | [firmware_
fromTFTP [<ipaddr> | <ipv6_addr>] <path_filename 64>
image_id <value 1-2>]
The download command downloads a firmware, boot, or switch
configuration file from a TFTP server.
cfg_fromTFTP − Downloads a switch configuration file from a TFTP
server.
<ipaddr> − The IPv4 address of the TFTP server.
<ipv6_addr> − The IPv6 address of the TFTP server.
<path_filename 64> − The DOS path and filename of the switch
configuration file, up to 64 characters, on the TFTP server. For
example, C:\ DES-1210-52ME-C1-20-01-B052-ALL.hex.
config_id <value 1-2> − Specify the config id to be download.
firmware_fromTFTP − Downloads and installs firmware on the
Switch from a TFTP server.
< path_filename 64> − The DOS path and filename of the firmware
108
15