Config Loopdetect Mode; Config Loopdetect Ports - D-Link DES-1210-52/ME Cli Reference Manual

Example usage:
To disable the loopback detection feature on the Switch:

config loopdetect mode

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the loopback detection mode to be portabse on the Switch:

config loopdetect ports

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the loop back detection on the Switch:
DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
DES-1210-52/ME:5# disable loopdetect
Command: disable loopdetect
Success.
DES-1210-52/ME:5#
To configure the loop back detection mode to be portbase or
vlanbase on the Switch.
config loopdetect mode [portbase | vlanbase]
The config loopdetect mode command configures loop back
detection mode to be portbase or vlanbase on the Switch.
[portbase | vlanbase]] - Specifies the loopdetect mode to be
portbase or vlanbase.
Only administrator-level users can issue this command.
DES-1210-52/ME:5# config loopdetect mode portbase
Command: config loopdetect mode portbase
Success.
DES-1210-52/ME:5#
To configures the loop back detection to be enabled or disabled for
the specific ports on the Switch.
config loopdetect ports [<portlist> | all] state [enable | disable]
The config loopdetect ports command configures the loop back
detection to be enabled or disabled for the specific ports on the
Switch.
<portlist> − A port or range of ports to be configured.
all − All ports settings are to be configured.
state [enabled | disabled] − Specifies the loop back detection is
enabled or disabled for the specified ports on the Switch.
Only administrator-level users can issue this command.
DES-1210-52/ME:5# config loopdetect ports all enable
Command: config loopdetect ports all enable
48