Routing Table Commands; Create Iproute - D-Link DES-1210-52/ME Cli Reference Manual

The Routing table commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command

create iproute

delete iproute
show iproute
Each command is listed in detail, as follows:
create iproute
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To add the default static address 10.90.90.92 to the routing table:
DES-1210-52/ME:5# create iproute default 10.90.90.92
Command: create iproute default 10.90.90.92
Success.
DES-1210-52/ME:5#
DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide

ROUTING TABLE COMMANDS

Parameter
default <ipaddr> {<value 1-254>}
{default}
{<ipaddr> | static}
Used to create IP route entries to the Switch's IP routing table.
create iproute default <ipaddr> {<value 1-254>}
The create iproute command is used to create a default static IP
route entry to the Switch's IP routing table.
default – Specifies to create a default IP route entry.
<ipaddr> − The gateway IP address for the next hop router.
<value 1-254> − Allows the entry of a routing protocol metric entry,
representing the number of routers between the Switch and the IP
address above. The default setting is 1.
Only Administrator, operator and power user-level users can issue
this command.
331
44