Config Mld_Snooping Querier - D-Link DES-1210-52/ME Cli Reference Manual

Restrictions
Example usage:
To define the MLD snooping mrouter forbidden:
DES-1210-52/ME:5# config mld_snooping mrouter_ports_forbidden vlanid
1 add 8
Command: config mld_snooping mrouter_ports_forbidden vlanid 1 add 8
Success.
DES-1210-52/ME:5#

config mld_snooping querier

Purpose
Syntax
Description
Parameters
DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
only to this previously created VLAN.
vlanid <vidlist> – specifies that the mld snooping applies only to this
previously created VLAN id.
all – specifies that MLD snooping is to be configured for all VLANs
on the Switch.
add – Adds a specified port to the mld snooping mrouter port.
delete – Deletes a specified port to the mld snooping mrouter port.
<portlist> – Defines the ports to be included from the mld snooping
mrouter group.
Only administrato–level users can issue this command.
Used to configure the timers and settings for the MLD snooping
querier for the Switch.
config mld_snooping querier [vlan_name <string 32> | vlanid
<vidlist> | all] [last_listener_query_interval <sec 1-25> |
max_response_time <sec 10-25> | query_interval <sec 60-600> |
robustness_variable <value 2-255> | state [enable | disable] |
version <value 1-2>]
The config mld_snooping querier command allows users to
configure the time between general query transmissions, the
maximum time to wait for reports from listeners and the permitted
packet loss guaranteed by MLD snooping.
vlan_name <string 32> – Specifies that the mld snooping applies
only to this previously created VLAN.
vlanid <vidlist> – specifies that the mld snooping applies only to this
previously created VLAN id.
all – specifies that MLD snooping is to be configured for all VLANs
on the Switch.
last_listener_query_interval <sec 1-25> – The maximum amount of
time to be set between group-specific query messages. This interval
may be reduced to lower the amount of time it takes a router to
detect the loss of a last listener group. The user may set this interval
between 1 and 25 seconds with a default setting of 1 second.
max_response_time <sec 10-25> – The maximum time to wait for
reports from listeners. The user may specify a time between 1 and
25 seconds with a default setting of 10 seconds.
query_interval <sec 60-600> – Specifies the amount of time
between general query transmissions. The user may specify a time
between 1 and 65535 seconds with a default setting of 125 seconds.
robustness_variable <value 2-255> – Provides fine-tuning to allow
284