Config Lldp Tx_Delay; Config Lldp Notification_Interval; Show Lldp - D-Link DES-1210-52/ME Cli Reference Manual

config lldp tx_delay

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure LLDP tx delay:
DES-1210-52/ME:5# config lldp tx_delay 1
Command: config lldp tx_delay 1
Success.
DES-1210-52/ME:5#

config lldp notification_interval

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To change the notification interval:
DES-1210-52/ME:5# config lldp notification_interval 10
Command: config lldp notification_interval 10
Success.
DES-1210-52/ME:5#

show lldp

Purpose
Syntax
Description
DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
To configure the lldp tx_delay on the switch.
config lldp tx_delay <sec 1-8192>
The config lldp tx_delay command specifies the delay between
Success.ive LLDP frame transmissions initiated by value/status
changes in the LLDP local systems MIB, use the lldp tx_delay
command in global configuration mode.
<sec 1-8192> – Specifies the minimum time in seconds an LLDP
port will wait before reinitializing LLDP transmission. The range is
1 – 8192 seconds. The default configuration is 2 seconds.
Only Administrator or operator-level users can issue this command.
To configure the timer of the notification interval used to send
notifications to configured SNMP trap receiver(s).
config lldp notification_interval <sec 5-3600>
The config lldp notification_interval command globally changes
the interval between Success.ive LLDP change notifications
generated by the switch.
<sec 5-3600> – The range is from 5 second to 3600 seconds. The
default setting is 5 seconds.
Only Administrator or operator-level users can issue this command.
To display the Link Layer Discovery Protocol (LLDP) on the switch.
show lldp
The show lldp displays the LLDP configuration on the switch.
384