Config Pppoe Circuit_Id_Insertion Ports; Show Pppoe Circuit_Id_Insertion - D-Link DES-1210-52/ME Cli Reference Manual

Success.
DES-1210-52/ME:5#

config pppoe circuit_id_insertion ports

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable port 1~5 PPPoE circuit ID insertion function and use Host MAC:
DES-1210-52/ME:5# config pppoe circuit_id_insertion ports 1-5 circuit_id
mac state enable
Command: config pppoe circuit_id_insertion ports 1-5 circuit_id mac
state enable
Success.
DES-1210-52/ME:5#

show pppoe circuit_id_insertion

Purpose
Syntax
Description
DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
Used to enable and disable PPPoE circuit identifier insertion on a
per port basis and specify how to encode the circuit ID option.
config pppoe circuit_id_insertion ports <portlist> [ circuit_id
[ mac | ip | udf <string 32> ] | state [enable | disable ] ]
When the port's state and the global state are enabled, the system
will insert the Circuit ID TAG to the received PPPoE discovery
initiation and request packet if the TAG is absent, and remove the
Circuit ID tag, inserted by the system, from the received PPPoE offer
and session confirmation packet.
<portlist> – Specifies a list of ports to be configured.
The default settings are enabled for ID insertion per port, but
disabled globally.
circuit_id – Configures the device ID used for encoding of the circuit
ID option.
mac – Specifies that the Switch MAC address be used to encode the
circuit ID option.
ip – Specifies that the Switch IP address be used to encode the
circuit ID option.
udf – A user defined string to be used to encode the circuit ID option.
The maximum length is 32.
The default encoding for the device ID option is the Switch IP
address.
state – Specify to enable or disable PPPoE circuit ID insertion for the
ports listed.
Only administrator or operate-level users can issue this command.
Used to display the PPPoE circuit identifier insertion status for the
Switch.
show pppoe circuit_id_insertion
The show pppoe circuit_id_insertion command is used to display
55