D-Link DES-1210-52/ME Cli Reference Manual page 417

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
more of the following:

source_ip <ipaddr> – Specifies that the access profile
applies only to packets with this source IP address.

protocol_id <value 0-255> – Specifies that the Switch
examine the Protocol field in each packet and if this field
contains the value entered here, apply the appropriate rules.

destination_ip <ipaddr> – Specifies that the access profile
applies only to packets with this destination IP address.

dscp <value 0-63> – Specifies that the access profile
applies only to packets that have this value in their Type-of-
Service (DiffServ code point, DSCP) field in their IP packet
header.

icmp – Specifies that the Switch examine the protocol field
in each frame's header and it should match Internet Control
Message Protocol (ICMP).

type – Specifies that the Switch examine each frame's ICMP
Type field.

code – Specifies that the Switch examine each frame's
ICMP Code field.

igmp – Specifies that the Switch examine each frame's
protocol and it should match Internet Group Management
Protocol (IGMP) field.

type – Specifies that the Switch examine each frame's IGMP
Type field.

tcp - Specifies that the Switch examine each frame's
protocol and it should matchTransport Control Protocol
(TCP) field.

src_port <value 0-65535> – Specifies that the access profile
applies only to packets that have this TCP source port in
their TCP header.

dst_port <value 0-65535> – Specifies that the access profile
applies only to packets that have this TCP destination port in
their TCP header.

flag {+ | –} {urg | ack | psh | rst | syn | fin }} – Specifies the
appropriate flag parameter. All incoming packets have TCP
flag bits associated with them which are parts of a packet
that determine what to do with the packet. The user may
deny packets by denying certain flag bits within the packets.
To specify flag bits that should be "1" type + and the flag bit
name, to specify bits that should be "0" type – and the flag
bit name.

udp – Specifies that the Switch examine the protocol field in
each packet and it should match User Datagram Protocol
(UDP).

src_port <value 0-65535> – Specifies that the access profile
applies only to packets that have this UDP source port in
their header.

dst_port <value 0-65535> – Specifies that the access profile
applies only to packets that have this UDP destination port
in their header.
Ipv6 – Specifies that the Switch examines the IPv6 fields in each
packet with special emphasis on one or more of the following:
class <value 0-255> – Examine the class field of IPv6 header.
The range is 0 to 255.
399