Config Dhcp_Relay Port; Config Dhcp_Relay Add Ipif System - D-Link DES-1210-52/ME Cli Reference Manual

config dhcp_relay port

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable ports 1-4 of DHCP Relay server:

config dhcp_relay add ipif System

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To add a DHCP server as a DHCP Relay server:
DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
To enable or disable the ports of DHCP Relay server.
config dhcp_relay port <portlist> state [enable | disable]
The config dhcp_relay port command is used to enable or disable
the ports of DHCP Relay server.
<portlist> − Specifies the ports to be configured.
state [enable | disable] – Specifies the ports of DHCP Relay server
to be enabled or disabled.
Only Administrator, operator or power user-level users can issue this
command.
DES-1210-52/ME:5# config dhcp_relay port 1-4 state enable
Command: config dhcp_relay port 1-4 state enable
Success.
DES-1210-52/ME:5#
To define a DHCP server as a DHCP Relay server
config dhcp_relay add ipif System <ipaddr>
The config dhcp_relay add ipif System command adds DHCP
servers as DHCP Relay servers.
<ipaddr> − The IP address of the DHCP server. Up to 4 servers can
be defined.
Only Administrator, operator or power user-level users can issue this
command.
DES-1210-52/ME:5# config dhcp_relay add ipif System 10.90.90.95
Command: config dhcp_relay add ipif System 10.90.90.95
Success.
DES-1210-52/ME:5#
116