The CPU Protection commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command
enable cpu_protect
disable cpu_protect
config cpu_protect
show cpu_protect
Each command is listed in detail, as follows:
enable cpu_protect
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the CPU protection function on the switch:
DES-1210-52/ME:5# enable cpu_protect
Command: enable cpu_protect
Success.
DES-1210-52/ME:5#
disable cpu_protect
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable the CPU protection function on the switch:
DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
CPU PROTECTION COMMANDS
Parameter
[arp | bpdu | icmp | igmp | snmp] pps [<value> | no_limit]
To enable the CPU protection function on the Switch.
enable cpu_protect
The enable cpu_protect command is used to enable the CPU
protection function on the Switch.
None.
Only Administrator or operator–level users can issue this command.
To disable the CPU protection function on the Switch.
disable cpu_protect
The disable cpu_protect command is used to disable the CPU
protection function on the Switch.
None.
Only Administrator or operator–level users can issue this command.
129
17 1